Saturday 3 September 2016

Irresistibly Floral

My Irresistibly Floral DSP Card Creation

The theme today is CASEing ...

In am sure most of you understand what CASEing is...For those that don't here is a rough outline

You can either Copy And Selective Edit OR Copy And Share Everything.

I have chose to Copy & Selective Edit. 
This is my favourite way to CASE. As it gives you a base to work with and lets you create a card all of your own.
Today's CASE inspirations came from Jessie Holton's new CHALLENGE site and her very first challenge is this gorgeous creation! #CTC001

#CTC001


The other inspiration came from this sketch challenge from CasethisSketch & their sketch this week is this lovely design.

#CTS188

I don't actually own the Falling Flowers stamp set which is what has been used in Jessie Holton's Card BUT I had purchased the thoroughly divine 'Irresistible Floral DSP' collection. 
I knew I could work with that & Jessie had used the same DSP on her card too. I also chose to use the same colour scheme as Jessie.

Here is my card

IRRESISTIBLY FLORAL


#IrresistiblyfloralDSP #KOCreationscards #Fussycutting #Resistembosstechnique #Windowsheet #Handmade



  • I started with Flirty Flamingo as my card base cut to 10.5 cm x 15 cm. 
  • I then cut a piece of Acetate Window Sheet to 10.5 x 18 cm. I folded that at 15 cm this will leave a 3 cm piece to attach to the card base. 
  • I  cut the front of the card base in half at 7.5 cm 
  • The loose 7.5 cm piece  I then cut in half again making 2 thinner strips.
  • I joined the window sheet to the front of the card using 'Tear & Tape' and a small amount of glue to the outside of the 3 cm Acetate window flap and pressing that to the top inside of the card base.
  • I added Tear & Tape to the inside on front 7.5 cm 'Flirty Flamingo' card base to secure this to the Acetate window.
  • I took 1 of the 2 thin strips of 'Flirty Flamingo' and adhered that to the bottom of the Acetate Window Sheet in the same manner as previously mentioned.

#IrresistiblyfloralDSP #KOCreationscards #Fussycutting #Resistembosstechnique #Windowsheet #Handmade

  • For the front and the inside section I cut 1 strip off the 'Falling Flowers' sheet from the 'Irresistibly Floral DSP' collection to 10 cm x 16 cm
  • I cut this strip into 3 sections
1 x 7 cm 
  1 x 5.5 cm
  1 x 3.5 cm
  • I coloured these blending the 'Pool Party' & 'So Saffron' ink pads using 'Stamping Sponges'.
  • Once blended the way I desired, I used my Paper-Piercing tool and a ruler to make a false stitch line placing a mark every 2 mm. 
  • I then used my 'Pool Party' Stampin' Write marker to add extra colour for the stitches.
  • I fussy cut some of the flowers from the same sheet of  DSP and coloured those with the sponges & ink then arranged them accordingly.
  • I cut a small piece of 'Bermuda Bay' Sequin Trim and added that to my flower arrangement. 
  • I added enamel shapes in Peekaboo Peach to the fussy cut flower centres.

Enamel Shapes are part of this weeks 'Promotion' at top of the page.

  • Using thick bakers twine in 'Whisper White' to edge the window sheet and the inside sponged DSP.
  • Using A piece of 'Bermuda Bay' card stock I stamped in 'Whisper White' the sentiment from the Gift of Love stamp set. 
  • I cut this in half to create two thin strips and then trimmed one end to a point.

The 'GIFT OF LOVE' stamp set is only available as a hostess gift to those who host a party or work shop either online or in home. If you are interested in hosting your own feel free to contact me.

Blending Correctly

  • To get a smooth blend using Stampin' Sponges & ink pads, I cut my round Stampin' Sponges down into 8 small wedges! 
  • I first press the chosen colour ink onto the stamp lid then holding the piece of sponge & pinching the sponge just above the widest end, wipe the ink in the lid all around it. Vigorously! 
  • I then dab the ink back onto the lid once or twice even three times, this helps to remove & spread evenly any large splotches that may have gathered. 
  • Always practice on a scrap piece first before starting on your project!
  • Always use a scratch paper under your work, so you can work from the outside of your paper in a circling motion, moving inwards.
  • DO NOT rub backwards & forwards! 
  • ALWAYS apply your ink from the sponge to paper in a circular motion, moving from the off the paper, onto the outside of your work, slowly reaching the centre.
  • Reapply in this manner until the depth of colour that you require is achieved!
Happy Blending!



#IrresistiblyfloralDSP #KOCreationscards #Fussycutting #Resistembosstechnique #Windowsheet #Handmade

I hope you enjoyed my card project today & my tips have been helpful.

If you would like further information please ask me below in the comments.


Thank you for stopping by.





If you would like to purchase any of the items used for this project please take a look at the carousal below.

                                                       
                        
             




18 comments:

  1. Oh my gosh, this card so many beautiful elements to it! Thank you for sharing & for entering it on the Case This Card! Challenge xx

    ReplyDelete
    Replies
    1. Thank you Jessie, am so happy you like my efforts. Love your new site too btw x

      Delete
  2. Oh, this is so pretty! I love the clear panel!

    ReplyDelete
    Replies
    1. I thank you Leigh for stopping by my blog and that you liked my card creating enough to comment. It means alot to me :-)
      The clear panel adds an extra element of interest and depth doesn't it!?!

      Delete
  3. Such a pretty card! Thanks for joining us at CAS(E) This Sketch!

    ReplyDelete
  4. This is a stunning card Kim!

    ReplyDelete
    Replies
    1. Thank you so very much Kaylene :-)so happy you like it

      Delete
  5. Beautiful card Kim, I adore the stitching too, that added little touch :)

    ReplyDelete
    Replies
    1. Thanks you Sue :-) I agree Sue it does add another dimension of interest and that extra special touch.

      Delete
  6. Beautiful card Kim. Love all the elements and detail - so perfectly made. Flawless ink blending too - Love it! :) x

    ReplyDelete
    Replies
    1. Ooooh thank you Juana such high praise from such a talented person as yourself. I think I have the hang of blending now :-)

      Delete
  7. Hi Kim, this is such a cute card! Love the panel and your blending of the colours on that fab DSP! Everything works so well together!

    ReplyDelete
    Replies
    1. Thank so very much Louise, I appreciate your lovely compliment x

      Delete
  8. Such a pretty card. I love the clear panel.

    ReplyDelete
    Replies
    1. Thank you Vanessa :-) the clear panel helps add some interest & gives you a peek into the inside also.

      Delete
  9. I simply adore everything about this card Kim. Love the panel detail ;-)

    ReplyDelete

Thank you for taking a moment to leave your comment. You have made my day :-)